C613-50100-01 REV C Command Reference for x930 Series 3075
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SFLOW COMMANDS
SFLOW
SAMPLING-RATE
sflow sampling-rate
Overview This command sets the mean sFlow® sampling rate for the specified ports.
Sampling occurs every N frames (on average), where N is the rate value set via this
command. The sampling rate applies to ingress and egress frames independently.
For example, a value of 1000 will sample one frame in every 1000 frames received,
i.e. one in every 1000 frames sent from the specified port. A value of 0 disables
sampling on the specified port(s).
The no variant of this command applies the default.
Syntax
sflow sampling-rate {0|<256-16777215>}
no sflow sampling-rate
Default The sampling-rate is 0 (sampling disabled).
Mode Interface Configuration
Example To set the sampling rate to 500 for ports 1.0.1 and 1.0.7, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.7
awplus(config-if)# sflow sampling-rate 500
Related
Commands
show running-config sflow
show sflow interface
Parameter Description
0 Sets the default.
<256-16777215> The sampling rate N, measured in Ethernet frames.
To Next Page
Loading...
Need help?
General
