C613-50100-01 REV C Command Reference for x930 Series 1829
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-DM COMMANDS
DEBUG
PIM DENSE-MODE ALL
debug pim dense-mode all
Overview This command enables PIM-DM debugging.
The no variant of this command disables PIM-DM debugging.
Syntax
debug pim dense-mode all
no debug pim dense-mode all
Mode Privileged Exec and Global Configuration
Example
awplus# configure terminal
awplus(config)# debug pim dense-mode all
Output Figure 36-1: Example output from the debug pim dense-mode all command
Validation
Commands
show debugging pim dense-mode
Related
Commands
debug pim dense-mode context
debug pim dense-mode decode
debug pim dense-mode encode
debug pim dense-mode fsm
debug pim dense-mode mrt
debug pim dense-mode nexthop
debug pim dense-mode nsm
debug pim dense-mode vif
PIM event debugging is on
PIM MFC debugging is on
PIM state debugging is on
PIM packet debugging is on
PIM incoming packet debugging is on
PIM outgoing packet debugging is on
To Next Page
Loading...
Need help?
General
