C613-50100-01 REV C Command Reference for x930 Series 534
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VLAN COMMANDS
SWITCHPORT
MODE TRUNK
switchport mode trunk
Overview Use this command to set the switching characteristics of the port to trunk.
Received frames are classified based on the VLAN characteristics, then accepted or
discarded based on the specified filtering criteria.
Syntax
switchport mode trunk [ingress-filter {enable|disable}]
Default By default, ports are in access mode, are untagged members of the default VLAN
(vlan1), and have ingress filtering on.
Mode Interface Configuration
Usage A port in trunk mode can be a tagged member of multiple VLANs, and an untagged
member of one native VLAN.
To configure which VLANs this port will trunk for, use the switchport trunk allowed
vlan command.
Example
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# switchport mode trunk ingress-filter enable
Validation
Command
show interface switchport
Parameter Description
ingress-filter Set the ingress filtering for the frames received.
enable Turn on ingress filtering for received frames. This is the default.
disable Turn off ingress filtering to accept frames that do not meet the
classification criteria.
To Next Page
Loading...
Need help?
General
