C613-50100-01 REV C Command Reference for x930 Series 179
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
USER ACCESS COMMANDS
LINE
line
Overview Use this command to enter line configuration mode for the specified VTYs or the
console. The command prompt changes to show that the device is in Line
Configuration mode.
Syntax
line vty <first-line> [<last-line>]
line console 0
Mode Global Configuration
Usage In Line Configuration mode, you can configure console and virtual terminal
settings, including setting speed (asyn), length (asyn), privilege level, and
authentication (login authentication) or accounting (accounting login) method
lists.
To change the console (asyn) port speed, use this line command to enter Line
Configuration mode before using the speed (asyn) command. Set the console
speed (Baud rate) to match the transmission rate of the device connected to the
console (asyn) port on your device.
Note that line configuration commands do not take effect immediately. Line
configuration commands take effect after one of the following commands or
events:
•issuing a clear line console command
•issuing a reboot command
• logging out of the current session
Examples To enter Line Configuration mode in order to configure all VTYs, use the
commands:
awplus# configure terminal
awplus(config)# line vty 0 32
awplus(config-line)#
Parameter Description
<first-line> <0-32> Specify the first line number.
<last-line> <0-32> Specify the last line number.
console The console terminal line(s) for local access.
vty Virtual terminal for remote console access.
To Next Page
Loading...
Need help?
General
