C613-50100-01 REV C Command Reference for x930 Series 1933
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
MAXIMUM
-ACCESS-LIST
maximum-access-list
Overview Sets the maximum number of filters that can be added to any access-list. These are
access-lists within the ranges <1-199>, <1300-1999> and <2000-2699> and
named standard and extended access-lists.
The no variant of this command removes the limit on the number of filters that can
be added to a software access-list
Syntax
maximum-access-list <1-4294967294>
no maximum-access-list
Mode Global Configuration
Example To set the maximum number of software filters to 200:
awplus# configure terminal
awplus(config)# maximum-access-list 200
Parameter Description
<1-4294967294> Filter range.
To Next Page
Loading...
Need help?
General
