C613-50100-01 REV C Command Reference for x930 Series 1664
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
MLD AND MLD SNOOPING COMMANDS
IPV
6 MLD SNOOPING FAST-LEAVE
ipv6 mld snooping fast-leave
Overview Use this command to enable MLD Snooping fast-leave processing. Fast-leave
processing is analogous to immediate-leave processing; the MLD
group-membership is removed as soon as an MLD leave group message is
received, without sending out a group-specific query.
Use the no variant of this command to disable fast-leave processing.
Syntax
ipv6 mld snooping fast-leave
no ipv6 mld snooping fast-leave
Default MLD Snooping fast-leave processing is disabled.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Usage This MLD Snooping command can only be configured on VLAN interfaces.
Examples This example shows how to enable fast-leave processing on the VLAN interface
vlan2.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 mld snooping fast-leave
This example shows how to enable fast-leave processing on the VLAN interface
vlan2- vlan4.
awplus# configure terminal
awplus(config)# interface vlan2-vlan4
awplus(config-if)# ipv6 mld snooping fast-leave
To Next Page
Loading...
Need help?
General
