EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1614 background imageLoading...
Page #1614 background image
C613-50100-01 REV C Command Reference for x930 Series 1614
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP SNOOPING MROUTER
ip igmp snooping mrouter
Overview Use this command to statically configure the specified port as a multicast router
port for IGMP Snooping for an interface. This command applies to interfaces
configured for IGMP Snooping.
Use the no variant of this command to remove the static configuration of the port
as a multicast router port.
Syntax
ip igmp snooping mrouter interface <port>
no ip igmp snooping mrouter interface <port>
Mode Interface Configuration for a VLAN interface.
Example To configure port1.0.2 statically as a multicast router interface for vlan2, use the
commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip igmp snooping mrouter interface port1.0.2
Related
Commands
show ip igmp snooping mrouter
Parameter Description
<port> The port may be a device port (e.g. port1.0.4), a static channel
group (e.g. sa3), or a dynamic (LACP) channel group (e.g. po4).

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals