C613-50100-01 REV C Command Reference for x930 Series 1042
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF COMMANDS
SHOW
IP OSPF NEIGHBOR
show ip ospf neighbor
Overview Use this command to display information on OSPF neighbors. Include the ospf-id
parameter with this command to display information about specified instances.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip ospf [<ospf-id>] neighbor <neighbor-ip-addr> [detail]
show ip ospf [<ospf-id>] neighbor detail [all]
show ip ospf [<ospf-id>] neighbor [all]
show ip ospf [<ospf-id>] neighbor interface <ip-addr>
Mode User Exec and Privileged Exec
Examples
awplus# show ip ospf neighbor detail
awplus# show ip ospf neighbor 1.2.3.4
awplus# show ip ospf neighbor interface 10.10.10.50 detail all
Output Note that before a device enters OSPF Graceful Restart it first informs its OSPF
neighbors. In the show output, the * symbol beside the Dead Time parameter
indicates that the device has been notified of a neighbor entering the graceful
restart state, as shown in the figures below.
Figure 26-18: Example output from the show ip ospf neighbor command
Parameter Description
<ospf-id> <0-65535> The ID of the router process for which
information will be displayed.
<neighbor-ip-addr> The Neighbor ID, entered as an IP address.
all Include downstatus neighbor.
detail Detail of all neighbors.
<ip-addr> IP address of the interface.
OSPF process 1:
Neighbor ID Pri State Dead Time Address Interface
10.10.10.50 1 Full/DR 00:00:38 10.10.10.50 vlan1
OSPF process 100:
Neighbor ID Pri State Dead Time Address Interface
10.10.11.50 1 Full/Backup 00:00:31 10.10.11.50 vlan2
awplus#show ip ospf 1 neighbor
OSPF process 1:
Neighbor ID Pri State Dead Time Address Interface
10.10.10.50 1 Full/DR 00:00:38* 10.10.10.50 vlan1
To Next Page
Loading...
Need help?
General
