C613-50100-01 REV C Command Reference for x930 Series 2410
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OPENFLOW COMMANDS
OPENFLOW
NATIVE VLAN
openflow native vlan
Overview Use this command to specify a VLAN as a native VLAN for the data plane ports. You
must create a VLAN using the vlan database command before specifying the VLAN
as a native VLAN.
Use the no variant of this command to change the native VLAN for the data plane
ports back to the default VLAN 1.
Syntax
openflow native vlan <1-4090>
no openflow native vlan
Default The native VLAN for the data plane ports is VLAN 1 by default.
Mode Global Configuration
Example To specify VLAN 100 as a native VLAN for the data plane ports:
awplus# configure terminal
awplus(config)# openflow native vlan 100
To change the native VLAN for the data plane ports back to the VLAN 1:
awplus# configure terminal
awplus(config)# no openflow native vlan
Related
Commands
show openflow config
Parameter Description
<vlan_id> VLAN ID in the range <1-4090>
To Next Page
Loading...
Need help?
General
