Allied Telesis AlliedWare Plus - Ipv6 Pim Exclude-Genid

C613-50100-01 REV C Command Reference for x930 Series 1784
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
IPV
6 PIM EXCLUDE-GENID
ipv6 pim exclude-genid
Overview Use this command to exclude the GenID option from Hello packets sent out by the
PIM-SMv6 module on a particular interface. This command is used to inter-operate
with older Cisco IOS versions.
Use the no variant of this command to revert to default settings.
Syntax
ipv6 pim exclude-genid
no ipv6 pim exclude-genid
Default By default, this command is disabled; the GenID option is included.
Mode Interface Configuration for a VLAN interface.
Examples
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 pim exclude-genid
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ipv6 pim exclude-genid