C613-50100-01 REV C Command Reference for x930 Series 2907
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
SHOW
LLDP
show lldp
Overview This command displays LLDP status and global configuration settings.
Syntax
show lldp
Mode User Exec and Privileged Exec
Example To display LLDP status and global configuration settings, use the command:
awplus# show lldp
Output
Table 2: Example output from the show lldp command
awplus# show lldp
LLDP Global Configuration: [Default Values]
LLDP Status ............... Enabled [Disabled]
Notification Interval ..... 5 secs [5]
Tx Timer Interval ......... 30 secs [30]
Hold-time Multiplier ...... 4 [4]
(Computed TTL value ....... 120 secs)
Reinitialization Delay .... 2 secs [2]
Tx Delay .................. 2 secs [2]
Port Number Type........... Ifindex [Port-Number]
Fast Start Count .......... 5 [3]
LLDP Global Status:
Total Neighbor Count ...... 47
Neighbors table last updated 0 hrs 0 mins 43 secs ago
Table 3: Parameters in the output of the show lldp command
Parameter Description
LLDP Status Whether LLDP is enabled. Default is disabled.
Notification
Interval
Minimum interval between LLDP notifications.
Tx Timer
Interval
Transmit interval between regular transmissions of LLDP
advertisements.
Hold-time
Multiplier
The holdtime multiplier. The transmit interval is multiplied
by the holdtime multiplier to give the Time To Live (TTL)
value that is advertised to neighbors.
Reinitialization
Delay
The reinitialization delay. This is the minimum time after
disabling LLDP transmit on a port before it can reinitialize
again.
To Next Page
Loading...
Need help?
General
