C613-50100-01 REV C Command Reference for x930 Series 1633
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
SHOW
IP IGMP GROUPS
show ip igmp groups
Overview Use this command to display the multicast groups with receivers directly
connected to the router, and learned through IGMP.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip igmp groups [<ip-address>|<interface> detail]
Mode User Exec and Privileged Exec
Example The following command displays local-membership information for all ports in all
interfaces:
awplus# show ip igmp groups
Output Figure 31-2: Example output from the show ip igmp groups command
Parameter Description
<ip-address> Address of the multicast group, entered in the form A.B.C.D.
<interface> Interface name for which to display local information.
IGMP Connected Group Membership
Group Address Interface Uptime Expires Last Reporter
224.0.1.1 port1.0.1 00:00:09 00:04:17 10.10.0.82
224.0.1.24 port1.0.2 00:00:06 00:04:14 10.10.0.84
224.0.1.40 port1.0.3 00:00:09 00:04:15 10.10.0.91
224.0.1.60 port1.0.3 00:00:05 00:04:15 10.10.0.7
224.100.100.100 port1.0.1 00:00:11 00:04:13 10.10.0.91
228.5.16.8 port1.0.3 00:00:11 00:04:16 10.10.0.91
228.81.16.8 port1.0.7 00:00:05 00:04:15 10.10.0.91
228.249.13.8 port1.0.3 00:00:08 00:04:17 10.10.0.91
235.80.68.83 port1.0.11 00:00:12 00:04:15 10.10.0.40
239.255.255.250 port1.0.3 00:00:12 00:04:15 10.10.0.228
239.255.255.254 port1.0.12 00:00:08 00:04:13 10.10.0.84
Table 1: Parameters in the output of the show ip igmp groups command
Parameter Description
Group
Address
Address of the multicast group.
Interface Port through which the group is reachable.
Uptime The time in weeks, days, hours, minutes, and seconds that this
multicast group has been known to the device.