C613-50100-01 REV C Command Reference for x930 Series 2253
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RADIUS COMMANDS
AUTH
RADIUS SEND SERVICE-TYPE
auth radius send service-type
Overview Use this command to enable the device to include the Service-Type(6) attribute in
RADIUS authentication requests. The Service-Type attribute has a value of:
• Framed(2) for 802.1x
• Call-Check(10) for MAC authentication
• Unbound(5) for Web authentication.
Use the no variant of this command to stop including the Service-Type attribute.
Syntax
auth radius send service-type
no auth radius send service-type
Mode Global Configuration
Example To send the Service-Type attribute, use the commands:
awplus# configure terminal
awplus(config)# auth radius send service-type
Related
Commands
auth radius send nas-identifier