C613-50100-01 REV C Command Reference for x930 Series 1332
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
SEND-COMMUNITY
neighbor send-community
Overview Use this command to specify that a community attribute should be sent to a BGP
or BGP4+ neighbor.
Use the no variant of this command to remove the entry for the community
attribute.
Syntax
neighbor <neighborid> send-community {both|extended|standard}
no neighbor <neighborid> send-community
{both|extended|standard}
Default Both standard and extended community attributes are sent to a neighbor.
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] Router Configuration and IPv6 Address Family Configuration
Usage This command is used to specify a community attribute to be sent to a neighbor.
The community attribute groups destinations in a certain community and applies
routing decisions according to those communities. On receiving community
attributes the router reannounces them to the neighbor. Only when the no
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
command, and neighbor route-map command.
When this parameter is used with this
command, the command applies on all peers in
the specified group.
both Sends Standard and Extended Community attributes. Specifying
this parameter with the no variant of this command results in no
standard or extended community attributes being sent.
extended Sends Extended Community attributes. Specifying this parameter
with the no variant of this command results in no extended
community attributes being sent.
standard Sends Standard Community attributes. Specifying this parameter
with the no variant of this command results in no standard
community attributes being sent.
To Next Page
Loading...
Need help?
General
