C613-50100-01 REV C Command Reference for x930 Series 666
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
POWER OVER ETHERNET COMMANDS
POWER
-INLINE ALLOW-LEGACY
power-inline allow-legacy
Overview This command enables detection of pre-IEEE 802.3af Power Ethernet standard
legacy Powered Devices (PDs).
The no variant of this command disables detection of pre-IEEE 802.3af Power
Ethernet standard legacy Powered Devices (PDs).
Syntax
power-inline allow-legacy
no power-inline allow-legacy
Default Detection of legacy PDs is enabled on all ports
Mode Global Configuration
Examples To disable detection of legacy PDs, use the following commands:
awplus# configure terminal
awplus(config)# no power-inline allow-legacy
To enable detection of legacy PDs, use the following commands:
awplus# configure terminal
awplus(config)# power-inline allow-legacy
Validation
Commands
show power-inline
show running-config power-inline
To Next Page
Loading...
