EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2240 background imageLoading...
Page #2240 background image
C613-50100-01 REV C Command Reference for x930 Series 2240
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AAA COMMANDS
SERVER
(RADSECPROXY-AAA)
server (radsecproxy-aaa)
Overview Use this command to add a server to the RadSecProxy AAA application. Local
RADIUS client applications will attempt, via the proxy, to communicate with any
RadSec servers that are operational (in addition to any non-TLS RADIUS servers
that are configured).
Use the no variant of this command to delete a previously-configured server from
the RadSecProxy AAA application.
Syntax
server {<hostname>|<ip-addr>} [timeout <1-1000>] [name-check
{on|off}]
no server {<hostname>|<ip-addr>}
Mode RadSecProxy AAA Configuration Mode
Usage The server may be specified by its domain name or by its IPv4 address. If a domain
name is used, it must be resolvable using a configured DNS name server.
Each server may be configured with a timeout; if not specified, the global timeout
value for RADIUS servers will be used. The global timeout may be changed using
the radius-server timeout command. The default global timeout is 5 seconds.
Each server may be configured to use certificate name-checking; if not specified,
the global behavior defined by server name-check or no server name-check will
be used. If name checking is enabled, the Common Name portion of the subject
field of the server’s X.509 certificate must match the domain name or IP address
specified in this command.
Parameter Description
<hostname> Hostname of RadSec server
<ip-addr>
Specify the client IPv4 address, in dotted decimal notation
(A.B.C.D).
timeout
Specify the amount of time that the RadSecProxy AAA application
should wait before receiving replies from this server. RADIUS
server timeout (which defaults to 5 seconds).
<1-1000>
Time in seconds to wait for a server reply.
name-check
Specify whether or not to enforce certificate name checking for
this client. If the parameter is not specified then the global
behavior, which defaults to on, is used.
on
Enable name checking for this client.
off
Disable name checking for this client.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals