C613-50100-01 REV C Command Reference for x930 Series 2600
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
SELECT-AREA
atmf select-area
Overview Use this command to access devices in an area outside the core area on the
controller network. This command will connect you to the remote area-master of
the specified area.
This command is only valid on AMF controllers.
The no variant of this command disconnects you from the remote area-master.
Syntax
atmf select-area {<area-name>|local}
no atmf select-area
Mode Privileged Exec
Usage After running this command, use the atmf working-set command to select the set
of nodes you want to access in the remote area.
Example To access nodes in the area Canterbury, use the command
controller-1# atmf select-area Canterbury
This displays the following output:
To return to the local area for controller-1, use the command
controller-1# atmf select-area local
Alternatively, to return to the local area for controller-1, use the command
controller-1# no atmf select-area
Related
Commands
atmf working-set
Parameter Description
<area-name> Connect to the remote area-master of the area with this name.
local Return to managing the local controller area.
Test_network[3]#atmf select-area Canterbury
==============================================
Connected to area Canterbury via host Avensis:
==============================================
To Next Page
Loading...
Need help?
General
