C613-50100-01 REV C Command Reference for x930 Series 3046
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PING-POLLING COMMANDS
IP
(PING-POLLING)
ip (ping-polling)
Overview This command specifies the IPv4 address of the device you are polling.
Syntax
ip {<ip-address>|<ipv6-address>}
Mode Ping-Polling Configuration
Examples To set ping-poll instance 5 to poll the device with the IP address 192.168.0.1,
use the commands:
awplus# configure terminal
awplus(config)# ping-poll 5
awplus(config-ping-poll)# ip 192.168.0.1
To set ping-poll instance 10 to poll the device with the IPv6 address 2001:db8::,
use the commands:
awplus# configure terminal
awplus(config)# ping-poll 10
awplus(config-ping-poll)# ip 2001:db8::
Related
Commands
ping-poll
source-ip
show ping-poll
Parameter Description
<ip-address> An IPv4 address in dotted decimal notation A.B.C.D
<ipv6-address> An IPv6 address in hexadecimal notation X:X::X:X
To Next Page
Loading...
Need help?
General
