Allied Telesis AlliedWare Plus - Switchport Port-Security Aging

C613-50100-01 REV C Command Reference for x930 Series 503
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
SWITCHPORT
PORT-SECURITY AGING
switchport port-security aging
Overview Use this command to set MAC addresses that have been learned by port security
to age out.
Use the no variant of this command to set the MAC addresses to not age out.
Syntax
switchport port-security aging
no switchport port-security aging
Mode Interface Configuration
Examples To set port1.0.4 so that the MAC addresses that have been learned by port security
age out, use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# switchport port-security aging
To stop the MAC addresses that have been learned by port security from aging out
on port1.0.4, use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# no switchport port-security aging
Related
Commands
clear port-security intrusion
show port-security interface
show port-security intrusion
switchport port-security
switchport port-security maximum
switchport port-security violation