Allied Telesis AlliedWare Plus - Ip Route Static Inter-Vrf

C613-50100-01 REV C Command Reference for x930 Series 1503
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRF LITE COMMANDS
IP
ROUTE STATIC INTER-VRF
ip route static inter-vrf
Overview Applying this command enables static inter-VRF routing. Note that static inter-VRF
routing must be enabled before you can use the ip route command to create a
static inter-VRF route.
The no variant of this command disables static inter-VRF routing.
Syntax
ip route static inter-vrf
no ip route static inter-vrf
Mode VRF Configuration
Default Static inter-VRF routing is enabled.
Example To enable static inter-VRF routing, use the following commands:
awplus# config terminal
awplus(config)# ip route static inter-vrf
Related
Commands
show ip route