52
C613-50100-01 REV C Command Reference for x930 Series 2466
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRRP Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
the Virtual Router Redundancy Protocol (VRRP). For more information, see the
VRRP Feature Overview and Configuration Guide.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Command List •“advertisement-interval” on page 2468
•“circuit-failover” on page 2470
•“debug vrrp” on page 2472
•“debug vrrp events” on page 2473
•“debug vrrp packet” on page 2474
•“disable (VRRP)” on page 2475
•“enable (VRRP)” on page 2476
•“preempt-mode” on page 2477
•“priority” on page 2479
•“router ipv6 vrrp (interface)” on page 2481
•“router vrrp (interface)” on page 2483
•“show debugging vrrp” on page 2485
•“show running-config router ipv6 vrrp” on page 2486
•“show running-config router vrrp” on page 2487
•“show vrrp” on page 2488
•“show vrrp counters” on page 2490
•“show vrrp ipv6” on page 2493
•“show vrrp (session)” on page 2494
To Next Page
Loading...
Need help?
General
