Allied Telesis AlliedWare Plus - Chapter 8 Pluggables and Cabling Commands; Introduction

8
C613-50100-01 REV C Command Reference for x930 Series 302
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Pluggables and
Cabling Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
and monitor Pluggables and Cabling, including:
• Cable Fault Locator for finding faults in copper cabling
• Optical Digital Diagnostic Monitoring (DDM) to help find fiber issues when
links go down
• Active Fiber Monitoring for detecting changes in optical power received over
fiber cables.
For more information, see the Pluggables and Cabling Feature Overview and
Configuration_Guide.
Command List •“clear test cable-diagnostics tdr” on page 303
•“debug fiber-monitoring” on page 304
•“fiber-monitoring action” on page 306
•“fiber-monitoring baseline” on page 307
•“fiber-monitoring enable” on page 309
•“fiber-monitoring interval” on page 310
•“fiber-monitoring sensitivity” on page 311
•“show system fiber-monitoring” on page 313
•“show system pluggable” on page 316
•“show system pluggable detail” on page 318
•“show system pluggable diagnostics” on page 323
•“show test cable-diagnostics tdr” on page 327
•“test cable-diagnostics tdr interface” on page 328