C613-50100-01 REV C Command Reference for x930 Series 485
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
SHOW
LOOP-PROTECTION
show loop-protection
Overview Use this command to display the current loop protection setup for the device.
Syntax
show loop-protection [interface <port-list>] [counters]
Mode User Exec and Privileged Exec
Usage This command is used to display the current configuration and operation of the
Loop Protection feature
Examples To display the current configuration status, use the command:
awplus# show loop-protection
Figure 14-4: Example output from the show loop-protection command
To display the counter information, use the command:
awplus# show loop-protection counters
Figure 14-5: Example output from the show loop-protection counters
command
Parameter Description
interface The interface selected for display.
<port-list> A port, a port range, or an aggregated link.
counters Displays counter information for loop protection.
awplus#show loop-protection
LDF Interval: 10
LDF Rx Window: 3
Fast Block: Disabled
Timeout
Int Enabled Action Status Timeout Remain Rx port
--------------------------------------------------------------------------
port1.0.1 Yes vlan-dis Normal 7 - -
port1.0.2 Yes vlan-dis Normal 7 - -
port1.0.3 Yes vlan-dis Normal 7 - -
...
To Next Page
Loading...
Need help?
General
