C613-50100-01 REV C Command Reference for x930 Series 1116
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
SHOW
DEBUGGING IPV6 OSPF
show debugging ipv6 ospf
Overview Use this command in User Exec or Privileged Exec modes to display which OSPFv3
debugging options are currently enabled.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show debugging ipv6 ospf
Mode User Exec and Privileged Exec
Example
awplus# show debugging ipv6 ospf
Output Figure 27-1: Example output from the show debugging ipv6 ospf command
OSPFv3 debugging status:
OSPFv3 all packet detail debugging is on
OSPFv3 all IFSM debugging is on
OSPFv3 all NFSM debugging is on
OSPFv3 all LSA debugging is on
OSPFv3 all NSM debugging is on
OSPFv3 all route calculation debugging is on
OSPFv3 all event debugging is on
To Next Page
Loading...
Need help?
General
