C613-50100-01 REV C Command Reference for x930 Series 1770
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
DEBUG
IPV6 PIM SPARSE-MODE
debug ipv6 pim sparse-mode
Overview Use this command to activate PIM-SMv6 debugging.
Use the no variant of this command to deactivate PIMv6 debugging. Note that the
undebug ipv6 pim sparse-mode command is an alias of the no variant of this
command.
Syntax
debug ipv6 pim sparse-mode [all] [events] [mfc] [mib] [nexthop]
[nsm] [state] [timer]
no debug ipv6 pim sparse-mode [all] [events] [mfc] [mib]
[nexthop] [nsm] [state] [timer]
Mode Privileged Exec and Global Configuration
Example
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# debug ipv6 pim sparse-mode all
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# debug ipv6 pim sparse-mode events
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# debug ipv6 pim sparse-mode nexthop
Parameter Description
all Activates/deactivates all PIM-SMv6 debugging.
events Activates debug printing of PIM-SMv6 events.
mfc Activates debug printing of MFC (Multicast Forwarding Cache).
mib Activates debug printing of PIM-SMv6 MIBs.
nexthop Activates debug printing of PIM-SMv6 next hop communications.
nsm Activates debugging of PIM-SMv6 NSM (Network Services Module)
communications.
state Activates debug printing of state transition on all PIM-SMv6 FSMs.
timer Activates debug printing of PIM-SMv6 timers.
To Next Page
Loading...
Need help?
General
