EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #435 background imageLoading...
Page #435 background image
C613-50100-01 REV C Command Reference for x930 Series 435
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PORT MIRRORING AND REMOTE MIRRORING COMMANDS
VLAN
MODE REMOTE-MIRROR-VLAN
vlan mode remote-mirror-vlan
Overview Use this command to create a single VLAN or a range of VLANs in remote mirror
mode to be used for remote mirroring.
Use the no variant of this command to remove the remote mirror VLAN from the
VLAN database and its configurations.
Syntax
vlan [<vid>|<vid-range>] mode remote-mirror-vlan
no vlan [<vid>|<vid-range>]
Default There is no remote mirror VLAN by default.
Mode VLAN Configuration
Usage This remote mirror VLAN needs to be configured on the remote mirroring source
device, the destination (receiving) device, and any devices in between that are to
forward the mirrored traffic. We recommend configuring this on the receiving
device and intermediate devices before configuring the source device.
The remote mirror VLAN operates in a special mode— all traffic on the remote
mirror VLAN is flooded, and no learning or CPU processing is done for packets in
the VLAN. BPDU packets (link-local packets used to control features like spanning
tree or AMF) are dropped on remote mirror VLANs.
Disabling the remote-mirroring VLAN on the source switch does not prevent the
mirrored packets from being sent with the remote-mirror VLAN tag. To stop the
mirroring, the command no remote-mirror interface must be used.
Example To create a VLAN with VLAN ID 3 in remote mirror VLAN mode, use the commands:
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# vlan 3 mode remote-mirror-vlan
To remove the remote mirror VLAN with ID 3, use the commands:
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# no vlan 3
Related
Commands
remote-mirror interface
show remote-mirror
Parameter Description
<vid> The VLAN ID of the remote mirroring VLAN to be created.
<vid-range> The range of VLAN IDs for the remote mirroring VLANs to be
created.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals