C613-50100-01 REV C Command Reference for x930 Series 2487
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRRP COMMANDS
SHOW
RUNNING-CONFIG ROUTER VRRP
show running-config router vrrp
Overview Use this command to show the running configuration for VRRP IPv4.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
See the VRRP Feature Overview and Configuration Guide for more information
about VRRPv3 IPv4 configuration details.
Syntax
show running-config router vrrp
Mode Privileged Exec, Global Configuration, Line Configuration, and Interface
Configuration.
Example The example below shows you how to display the running configuration for VRRP
IPv4:
awplus# show running-config router vrrp
Output Figure 52-2: Example output from the show running-config router vrrp
command
!
router vrrp 2 vlan2
circuit-failover vlan2 2
advertisement-interval 4
preempt-mode true
!