C613-50100-01 REV C Command Reference for x930 Series 1488
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRF LITE COMMANDS
CLEAR
IP BGP * (BGP ONLY)
clear ip bgp * (BGP only)
Overview Use this command to reset all BGP connections, either by fully resetting sessions or
by performing soft resets.
If VRF lite is configured, you can reset BGP connections for all VRF instances or for
a specified VRF instance.
Syntax
clear ip bgp *
clear ip bgp * in
clear ip bgp * out
clear ip bgp * soft [in|out]
clear ip bgp * in [prefix-filter]
Syntax (VRF lite) clear ip bgp * [vrf <vrf-name>]
clear ip bgp * [vrf <vrf-name>] in
clear ip bgp * [vrf <vrf-name>] out
clear ip bgp * [vrf <vrf-name>] soft [in|out]
clear ip bgp * in [prefix-filter]
Mode Privileged Exec
Parameter Description
* Clears all bgp peers.
in Indicates that incoming advertised routes will be cleared.
prefix-filter Specifies that a prefix-list will be sent, by the ORF mechanism, to
those neighbors with which the ORF capability has been
negotiated. The neighbors will be triggered to resend updates,
which match the prefix-list filter, to the local router. The local
router will then perform a soft reconfiguration.
out Indicates that outgoing advertised routes will be cleared.
soft in Soft inbound reset causes the neighbors to resend all their
updates to the local device, without resetting the connection or
clearing the entries in the local device. So, the local device stores
new updates, and uses them to systematically replace existing
table entries. This process can use a considerable amount of
memory.
soft out Soft outbound reset causes the device to simply resend all its
updates to the specified neighbor(s), without resetting the
connection, or clearing table entries.
vrf Applies the command to the specified VRF instance.
<vrf-name> The name of the VRF instance.
To Next Page
Loading...
Need help?
General
