31
C613-50100-01 REV C Command Reference for x930 Series 1586
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP and IGMP
Snooping
Commands
Introduction
Overview Devices running AlliedWare Plus use IGMP (Internet Group Management Protocol)
and MLD (Multicast Listener Discovery) to track which multicast groups their clients
belong to. This enables them to send the correct multimedia streams to the correct
destinations. IGMP is used for IPv4 multicasting, and MLD is used for IPv6
multicasting.
This chapter describes the commands to configure IGMP Querier behaviour and
selection, IGMP Snooping and IGMP Proxy.
Command List •“clear ip igmp” on page 1588
•“clear ip igmp group” on page 1589
•“clear ip igmp interface” on page 1590
•“debug igmp” on page 1591
•“ip igmp” on page 1592
•“ip igmp access-group” on page 1593
•“ip igmp flood specific-query” on page 1594
•“ip igmp immediate-leave” on page 1595
•“ip igmp last-member-query-count” on page 1596
•“ip igmp last-member-query-interval” on page 1597
•“ip igmp limit” on page 1598
•“ip igmp maximum-groups” on page 1599
•“ip igmp mroute-proxy” on page 1601
•“ip igmp proxy-service” on page 1602
•“ip igmp querier-timeout” on page 1603
•“ip igmp query-holdtime” on page 1604
To Next Page
Loading...
Need help?
General
