C613-50100-01 REV C Command Reference for x930 Series 1720
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SM COMMANDS
IP
PIM ACCEPT-REGISTER LIST
ip pim accept-register list
Overview Use this command to configure the ability to filter out multicast sources specified
by the given access-list at the Rendezvous Point (RP), so that the RP will
accept/refuse to perform the register mechanism for the packets sent by the
specified sources. By default, the RP accepts register packets from all multicast
sources.
Use the no variant of this command to revert to default.
Syntax
ip pim accept-register
list{<simplerange>|<exprange>|<access-list>}
no ip pim accept-register
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# ip pim accept-register list 121
awplus(config)# access-list 121 permit ip 100.1.1.1 0.0.0.0 any
Parameter Description
<simplerange> <100-199> IP extended access-list.
<exprange> <2000-2699> IP extended access list (expanded range).
<access-list> IP Named Standard Access list.