C613-50100-01 REV C Command Reference for x930 Series 1305
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
PASSIVE
neighbor passive
Overview Use this command to configure the local BGP or BGP4+ router to be passive with
regard to the specified BGP or BGP4+ neighbor. This has the effect that the BGP or
BGP4+ router will not attempt to initiate connections to this BGP or BGP4+
neighbor, but will accept incoming connection attempts from the BGP or BGP4+
neighbor.
Use the no variant of this command to disable this function.
Syntax
neighbor <neighborid> passive
no neighbor <neighborid> passive
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] Router Configuration
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
command, and neighbor route-map command.
When this parameter is used with this
command, the command applies on all peers in
the specified group.
To Next Page
Loading...
