Allied Telesis AlliedWare Plus - Show Debugging Power-Inline

C613-50100-01 REV C Command Reference for x930 Series 677
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
POWER OVER ETHERNET COMMANDS
SHOW
DEBUGGING POWER-INLINE
show debugging power-inline
Overview This command displays Power over Ethernet (PoE) debug settings.
Syntax
show debugging power-inline
Mode User Exec and Privileged Exec
Example To display PoE debug settings, use the following command:
awplus# show debugging power-inline
Output Figure 18-1: Example output from the show debugging power-inline
command
Related
Commands
debug power-inline
terminal monitor
awplus#show debugging power-inline
PoE Debugging status:
PoE Informational debugging is disabled
PoE Event debugging is disabled
PoE Power Management debugging is disabled

PoE NSM debugging is enabled