C613-50100-01 REV C Command Reference for x930 Series 149
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
SHOW
BOOT
show boot
Overview This command displays the current boot configuration. We recommend that the
currently running release is set as the current boot image.
Syntax
show boot
Mode Privileged Exec
Example To show the current boot configuration, use the command:
awplus# show boot
Output Figure 2-8: Example output from the show boot command when the current
boot config is on a USB storage device
awplus#show boot
Boot configuration
----------------------------------------------------------------
Current software : x930-5.4.6-1.1.rel
Current boot image : usb:/x930-5.4.6-1.1.rel
Backup boot image : flash:/x930-5.4.6-0.1.rel
Default boot config: flash:/default.cfg
Current boot config: usb:/my.cfg (file exists)
Backup boot config: flash:/backup.cfg (file not found)
Autoboot status : enabled
Table 1: Parameters in the output of the show boot command
Parameter Description
Current software The current software release that the device is using.
Current boot image The boot image currently configured for use during the
next boot cycle.
Backup boot image The boot image to use during the next boot cycle if the
device cannot load the main image.
Default boot
config
The default startup configuration file. The device loads
this configuration script if no file is set as the startup-
config file.
Current boot
config
The configuration file currently configured as the
startup-config file. The device loads this configuration file
during the next boot cycle if this file exists.
To Next Page
Loading...
Need help?
General
