EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2116 background imageLoading...
Page #2116 background image
C613-50100-01 REV C Command Reference for x930 Series 2116
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
AUTH
ROAMING ENABLE
auth roaming enable
Overview This command allows a supplicant to move to another authenticating interface
without reauthentication, providing the link is up for the interface that the
supplicant is is currently connected to.
The no variant of this command disables roaming authentication on an interface,
and forces a supplicant to be reauthenticated when moving between interfaces.
See the AAA and Port Authentication Feature Overview and Configuration Guide
for further information about this feature.
Syntax
auth roaming enable
no auth roaming enable
Default Roaming authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Usage Note that 802.1X port authentication, MAC-authentication, or Web-authentication
must be configured before using this feature. The port that the supplicant is
moving to must have the same authentication configuration as the port the
supplicant is moving from.
This command only enables roaming authentication for links that are up. If you
want roaming authentication on links that are down, you must also use the
command auth roaming disconnected.
Roaming Authentication cannot be enabled if DHCP snooping is enabled (service
dhcp-snooping command), and vice versa.
Examples To enable roaming authentication for port1.0.4, when using 802.1X
authentication, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# dot1x port-control auto
awplus(config-if)# auth roaming enable
To disable roaming authentication for port1.0.4, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# no auth roaming enable
To enable roaming authentication for authentication profile ‘student’, use the
commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# auth roaming enable

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals