C613-50100-01 REV C Command Reference for x930 Series 1977
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV6 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(IPV6 ACCESS-LIST EXTENDED TCP UDP FILTER)
(ipv6 access-list extended TCP UDP filter)
Overview Use this ACL filter to add a filter entry for an IPv6 source and destination address
and prefix, with a TCP (Transmission Control Protocol) or UDP (User Datagram
Protocol) source and destination port specified, to the current extended IPv6
access-list. If a sequence number is specified, the new entry is inserted at the
specified location. Otherwise, the new entry is added at the end of the access-list.
The no variant of this command removes a filter entry for an IPv6 source and
destination address and prefix, with a TCP or UDP source and destination port
specified, from the current extended IPv6 access-list. You can specify the filter
entry for removal by entering either its sequence number, or its filter entry profile.
Syntax [tcp|udp]
[<sequence-number>] {deny|permit} {tcp|udp}
{<ipv6-source-address/prefix>|any} {eq <sourceport>|lt
<sourceport>|gt <sourceport>|ne <sourceport>}
{<IPv6-destination-address/prefix>|any} {eq <destport>|lt
<destport>|gt <destport>|ne <destport>} [log]
no {deny|permit} {tcp|udp} {<ipv6-source-address/prefix>|any}
{eq <sourceport>|lt <sourceport>|gt <sourceport>|ne
<sourceport>}} {<IPv6-destination-address/prefix>|any} {eq
<destport>|lt <destport>|gt <destport>|ne <destport>} [log]
no <sequence-number>
Parameter Description
<sequence-number> <1-65535>
The sequence number for the filter entry of the selected
access control list.
deny Specifies the packets to reject.
permit Specifies the packets to accept.
tcp TCP packet.
udp UDP packet.
<ipv6-source-
address/prefix>
IPv6 source address, or local address.
The IPv6 address uses the format X:X::X:X/Prefix-Length. The
prefix-length is usually set between 0 and 64.
any Any source address or local address.
eq Equal to.
lt Less than.
gt Greater than.
ne Not equal to.
<sourceport> The source port number, specified as an integer between 0
and 65535.
To Next Page
Loading...
Need help?
General
