C613-50100-01 REV C Command Reference for x930 Series 2195
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
SHOW
AUTH SUPPLICANT
show auth supplicant
Overview This command shows the supplicant (client device) state when authentication is
configured for the switch. Use the optional brief parameter to show a summary of
the supplicant state.
Syntax
show auth supplicant [<macadd>] [brief]
Mode Privileged Exec
Examples To display a summary of authenticated supplicant information on the device, enter
the command:
awplus# show auth supplicant brief
To display authenticated supplicant information on the device, enter the
command:
awplus# show auth supplicant
To display authenticated supplicant information for device with MAC address
0000.5E00.5301, enter the command:
awplus# show auth supplicant 0000.5E00.5301
Output Figure 43-4: Example output from show auth supplicant brief
Parameter Description
<macadd> Mac (hardware) address of the supplicant.
Entry format is HHHH.HHHH.HHHH (hexadecimal).
brief Brief summary of the supplicant state.
awplus#show auth supplicant brief
Interface port2.0.3
authenticationMethod: dot1x/mac/web
Two-Step Authentication
firstMethod: mac
secondMethod: dot1x/web
totalSupplicantNum: 1
authorizedSupplicantNum: 1
macBasedAuthenticationSupplicantNum: 0
dot1xAuthenticationSupplicantNum: 0
webBasedAuthenticationSupplicantNum: 1
otherAuthenticationSupplicantNum: 0RADIUS Group Configuration
Interface VID Mode MAC Address Status IP Address Username
=========== ==== ==== ============== ================= =============== ========
port2.0.3 1 W 001c.233e.e15a Authenticated 192.168.1.181 test
To Next Page
Loading...
Need help?
General
