C613-50100-01 REV C Command Reference for x930 Series 1134
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
SHOW
IPV6 OSPF INTERFACE
show ipv6 ospf interface
Overview Use this command in User Exec or Privileged Exec modes to display interface
information for OSPF for all interfaces or a specified interface, including OSPFv3
Authentication status for all interfaces or for a specified interface.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 ospf interface [<interface-name>]
Mode User Exec and Privileged Exec
Examples
awplus# show ipv6 ospf interface vlan2
Output Figure 27-12: Example output from the show ipv6 ospf interface command
showing OSPFv3 Authentication configuration information
highlighted in bold
Parameter Description
<interface-name> An alphanumeric string that is the interface name. Omit the
optional interface to display OSPF
awplus#show ipv6 ospf interface
vlan2 is up, line protocol is up
Interface ID 302
IPv6 Prefixes
fe80::215:77ff:fead:f87e/64 (Link-Local Address)
Security Policy
MD5 Authentication SPI 1000
NULL Encryption SHA-1 Auth, SPI 1001
OSPFv3 Process (10), Area 0.0.0.0, Instance ID 0
Router ID 192.168.1.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State Backup, Priority 1
Interface state Backup
Designated Router (ID) 192.168.1.1
Interface Address fe80::21d:e5ff:fec9:cfbe
Backup Designated Router (ID) 192.168.1.2
Interface Address fe80::215:77ff:fead:f87e
Timer interval configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 00:00:07
Neighbor Count is 1, Adjacent neighbor count is 1
To Next Page
Loading...
Need help?
General
