C613-50100-01 REV C Command Reference for x930 Series 2599
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
RESTRICTED-LOGIN
atmf restricted-login
Overview This command restricts the use of the atmf working-set command on all AMF
master nodes to privilege 15 users only. Once entered on any AMF master node,
this command will propagate across the network.
Note that once you have run this command, certain other commands that utilize
the AMF working-set command, such as the include, atmf reboot-rolling and
show atmf group members commands, will operate only on master nodes.
Use the no variant of this command to disable restricted login on the AMF
network. This allows access to the atmf working-set command from any node in
the AMF network.
Syntax
atmf restricted-login
no atmf restricted-login
Mode Privileged Exec
Default Master nodes operate with atmf restricted-login disabled.
Member nodes operate with atmf restricted-login enabled.
NOTE: The default conditions of this command vary from those applied by its “no”
variant. This is because the restricted-login action is only applied by master nodes, and
in the absence of a master node, the default is to apply the restricted action to all
member nodes with AMF configured.
In the presence of a master node, its default of “atmf restricted-login disabled” will
permeate to all its member nodes. Similarly, any change in this command’s status that
is made on a master node, will also permeate to all its member nodes
Example To enable restricted login, use the command
Node_20(config)# atmf restricted-login node20
Validation
Command
show atmf
To Next Page
Loading...
Need help?
General
