C613-50100-01 REV C Command Reference for x930 Series 2087
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
802.1X COMMANDS
SHOW
DOT1X SUPPLICANT INTERFACE
show dot1x supplicant interface
Overview This command shows the supplicant state of the authentication mode set for the
interface, which may be a static channel (or static aggregator) or a dynamic (or
LACP) channel group or a switch port.
This command shows a summary when the optional brief parameter is used.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show dot1x supplicant interface <interface-list> [brief]
Mode Privileged Exec
Examples See sample output below showing the supplicant on the interface port1.0.6:
awplus# show dot1x interface port1.0.6
Parameter Description
<interface-list> The interfaces or ports to configure. An interface-list can be:
•an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
brief Brief summary of the Supplicant state.
To Next Page
Loading...
Need help?
General
