C613-50100-01 REV C Command Reference for x930 Series 487
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
SHOW
MAC ADDRESS-TABLE
show mac address-table
Overview Use this command to display the mac address-table for all configured VLANs.
Syntax
show mac address-table
Mode User Exec and Privileged Exec
Usage The show mac address-table command is only applicable to view a mac
address-table for Layer 2 switched traffic within VLANs.
Example To display the mac address-table, use the following command:
awplus# show mac address-table
Output See the below sample output captured when there was no traffic being switched:
See the sample output captured when packets were switched and mac addresses
were learned:
Note the new mac addresses learned for port1.0.4 and port1.0.6 added as
dynamic entries.
Note the first column of the output below shows VLAN IDs if multiple VLANs are
configured:
Also note manually configured static mac-addresses are shown to the right of the
type column:
awplus#show mac address-table
VLAN Port MAC State
1 unknown 0000.cd28.0752 static
ARP - 0000.cd00.0000 static
awplus#show mac address-table
VLAN Port MAC State
1 unknown 0000.cd28.0752 static
1 port1.0.6 0030.846e.9bf4 dynamic
1 port1.0.4 0030.846e.bac7 dynamic
ARP - 0000.cd00.0000 static
awplus#show mac address-table
VLAN Port MAC State
1 unknown 0000.cd28.0752 static
1 port1.0.4 0030.846e.bac7 dynamic
2 unknown 0000.cd28.0752 static
2 port1.0.6 0030.846e.9bf4 dynamic
ARP - 0000.cd00.0000 static
To Next Page
Loading...
Need help?
General
