C613-50100-01 REV C Command Reference for x930 Series 899
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
OFFSET
-LIST (RIP)
offset-list (RIP)
Overview Use this command to add an offset to the in and out metrics of routes learned
through RIP.
Use the no variant of this command to remove the offset list.
Syntax
offset-list <access-list> {in|out} <offset> [<interface>]
no offset-list <access-list> {in|out} <offset> [<interface>]
Default The default offset value is the metric value of the interface over which the updates
are being exchanged.
Mode RIP Router Configuration or RIP Router Address Family Configuration for a VRF
instance.
Usage Use this command to specify the offset value that is added to the routing metric.
When the networks match the access list the offset is applied to the metrics. No
change occurs if the offset value is zero.
Examples In this example the router examines the RIP updates being sent out from interface
vlan2 and adds 5 hops to the routes matching the ip addresses specified in the
access list 8.
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# offset-list 8 in 5 vlan2
To apply this same command within the specific VRF instance named blue, use
the following commands:
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# address-family ipv4 vrf blue
awplus(config-router-af)# offset-list 8 in 5 vlan2
Parameter Description
<access-list> Specifies the access-list number or names to apply.
in Indicates the access list will be used for metrics of incoming
advertised routes.
out Indicates the access list will be used for metrics of outgoing
advertised routes.
<offset> <0-16> Specifies that the offset is used for metrics of networks
matching the access list.
<interface> An alphanumeric string that specifies the interface to match.
To Next Page
Loading...
Need help?
General
