EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2582 background imageLoading...
Page #2582 background image
C613-50100-01 REV C Command Reference for x930 Series 2582
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
PROVISION NODE CONFIGURE BOOT SYSTEM
atmf provision node configure boot system
Overview This command sets the release file that will load onto a specified provisioned node
during the next boot cycle. This command can also set the backup release file to be
loaded for an AMF provisioned node. To unset the boot system release file or the
backup boot release file use the no boot command.
Use the no variant of this command to reeturn to the default.
This command can only be run on AMF master nodes.
Syntax
atmf provision node <nodename> configure boot system [backup]
[<file-path|URL>]
atmf provision node <nodename> configure no boot system [backup]
Default No boot release file or backup release files are specified for the provisioned node.
Mode Privileged Exec
Usage When using this command to set a backup release file, the specified AMF
provisioned node must exist. The specified file must exist in the flash directory
created for the provisioned node in the AMF remote backup media.
Examples To set the release file x610-5.4.6-1.4.rel on the AMF provisioned node “node1”, use
the command:
MasterNodeName# atmf provision node node1 configure boot system
x610-5.4.6-1.4.rel
To set the backup release file x610-5.4.6-1.4.rel as the backup to the main release
file on the AMF provisioned node “node1”, use the command:
MasterNodeName# atmf provision node node1 configure boot system
backup card:/atmf/amf_net/nodes/node1/flash/x610-5.4.6-1.4.rel
To unset the boot release, use the command:
MasterNodeName# atmf provision node node1 configure no boot
system
To unset the backup boot release, use the command:
MasterNodeName# atmf provision node node1 configure no boot
system backup
Related
Commands
atmf provision node configure boot config
show atmf provision nodes
Parameter Description
<nodename> The name of the provisioned node.
<file-path|URL> The path or URL and name of the release file.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals