Allied Telesis AlliedWare Plus - Chapter 58: SNMP Commands; Introduction; SNMP Commands

58
C613-50100-01 REV C Command Reference for x930 Series 2828
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SNMP Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
SNMP. For more information, see:
•the Support for Allied Telesis Enterprise_MIBs in AlliedWare Plus, for
information about which MIB objects are supported.
•the SNMP Feature Overview and Configuration_Guide.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Command List •“debug snmp” on page 2830
•“show counter snmp-server” on page 2831
•“show debugging snmp” on page 2835
•“show running-config snmp” on page 2836
•“show snmp-server” on page 2837
•“show snmp-server community” on page 2838
•“show snmp-server group” on page 2839
•“show snmp-server user” on page 2840
•“show snmp-server view” on page 2841
•“snmp trap link-status” on page 2842
•“snmp trap link-status suppress” on page 2844
•“snmp-server” on page 2846
•“snmp-server community” on page 2848
•“snmp-server contact” on page 2849
•“snmp-server enable trap” on page 2850
•“snmp-server engineID local” on page 2853