C613-50100-01 REV C Command Reference for x930 Series 886
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
IP
RIP SEND-PACKET
ip rip send-packet
Overview Use this command to enable sending RIP packets through the current interface.
Use the no variant of this command to disable this feature.
Syntax
ip rip send-packet
no ip rip send-packet
Default Send packet is enabled
Mode Interface Configuration for a VLAN interface.
Usage This command can only be configured on VLAN interfaces.
Example This example shows packet sending being turned on for the VLAN interface
vlan4:
awplus# configure terminal
awplus(config)# interface vlan4
awplus(config-if)# ip rip send-packet
Related
Commands
ip rip receive-packet
To Next Page
Loading...
