C613-50100-01 REV C Command Reference for x930 Series 1842
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-DM COMMANDS
IP
PIM HELLO-INTERVAL (PIM-DM)
ip pim hello-interval (PIM-DM)
Overview This command configures a PIM hello-interval value. The PIM hello-interval on a
VLAN interface is the period at which the router will transmit PIM hello messages
on that interface.
When the hello-interval is configured, and the hello-holdtime is not configured,
or when the configured hello-holdtime value is less than the new hello-interval
value; the hello-holdtime value is modified to 3.5 times the hello-interval value.
Otherwise, the hello-holdtime value is the configured value. The default is 30
seconds.
Use the no variant of this command to reset the hello-interval to the default.
Syntax
ip pim hello-interval <interval>
no ip pim hello-interval
Mode Interface Configuration for a VLAN interface.
Example
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip pim hello-interval 123
Parameter Description
<interval> <1-65535> The value in seconds (no fractional seconds accepted).
To Next Page
Loading...
Need help?
General
