C613-50100-01 REV C Command Reference for x930 Series 1086
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
DEFAULT
-INFORMATION ORIGINATE
default-information originate
Overview This command creates a default external route into an OSPF routing domain.
When you use the default-information originate command to redistribute
routes into an OSPF routing domain, then the system acts like an Autonomous
System Boundary Router (ASBR). By default, an ASBR does not generate a default
route into the OSPF routing domain.
When using this command, also specify the route-map <route-map> option to
avoid a dependency on the default network in the routing table.
The metric-type is an external link type associated with the default route
advertised into the OSPF routing domain. The value of the external route could be
either Type 1 or 2. The default is Type 2.
The no variant of this command disables this feature.
Syntax
default-information originate [always] [metric <metric>]
[metric-type <1-2>] [route-map <route-map>]
no default-information originate [always] [metric]
[metric-type] [route-map]
Mode Router Configuration
Example
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# default-information originate always
metric 23 metric-type 2 route-map myinfo
Related
Commands
route-map
Parameter Description
always Used to advertise the default route regardless of whether
there is a default route.
<metric> The metric value used in creating the default route. Enter a
value in the range 0 to 16777214.
The default metric value is 10. The value used is specific to
the protocol.
<1-2> External metric type for default routes, either OSPF External
Type 1 or Type 2 metrics. Enter the value 1 or 2.
route-map Specifies to use a specific route-map.
<route-map> The route-map name. It is a string comprised of any
characters, numbers or symbols.
To Next Page
Loading...
Need help?
General
