Allied Telesis AlliedWare Plus - Chapter 57: NTP Commands; Introduction; NTP Commands

57
C613-50100-01 REV C Command Reference for x930 Series 2804
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
NTP Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
the Network Time Protocol (NTP). For more information, see the NTP Feature
Overview and Configuration Guide.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Command List •“ntp access-group” on page 2805
•“ntp authenticate” on page 2806
•“ntp authentication-key” on page 2807
•“ntp broadcastdelay” on page 2808
•“ntp discard” on page 2809
•“ntp master” on page 2810
•“ntp peer” on page 2811
•“ntp restrict” on page 2813
•“ntp server” on page 2815
•“ntp source” on page 2817
•“ntp trusted-key” on page 2819
•“show counter ntp (deprecated)” on page 2820
•“show ntp associations” on page 2821
•“show ntp counters” on page 2823
•“show ntp counters associations” on page 2825
•“show ntp status” on page 2827