C613-50100-01 REV C Command Reference for x930 Series 1257
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
ATTRIBUTE-UNCHANGED
neighbor attribute-unchanged
Overview Use this command to advertise unchanged BGP or BGP4+ attributes to the
specified BGP or BGP4+ neighbor.
Use the no variant of this command to disable this function.
Syntax
neighbor <neighborid> attribute-unchanged
{as-path|next-hop|med}
no neighbor <neighborid> attribute-unchanged
{as-path|next-hop|med}
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] IPv6 Address Family Configuration
Usage Note that specifying this command with the optional as-path parameter has the
same effect as invoking the neighbor transparent-as command.
Note this specifying this command with the optional next-hop parameter has the
same effect as invoking the neighbor transparent-nexthop command.
Parameter Description
<neighborid> {<ip-address>|ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
command, and neighbor route-map command.
When this parameter is used with this
command, the command applies on all peers in
the specified group.
as-path AS path attribute.
next-hop Next hop attribute.
med Multi Exit Discriminator.
To Next Page
Loading...
