C613-50100-01 REV C Command Reference for x930 Series 2714
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
IP
DHCP-RELAY MAXHOPS
ip dhcp-relay maxhops
Overview This command sets the hop count threshold for discarding BOOTP messages.
When the hops field in a BOOTP message exceeds the threshold, the DHCP Relay
Agent discards the BOOTP message. The hop count threshold is set to 10 hops by
default.
Use the no variant of this command to reset the hop count to the default.
For DHCP Relay Agent and DHCP Relay Agent Option 82 introductory information,
see the DHCP Feature Overview and Configuration Guide.
Syntax
ip dhcp-relay maxhops <1-255>
no ip dhcp-relay maxhops
Default The default hop count threshold is 10 hops.
Mode Interface Configuration for a VLAN interface.
Example To set the maximum number of hops to 5 for packets received on interface
vlan15, use the commands:
awplus# configure terminal
awplus(config)# interface vlan15
awplus(config-if)# ip dhcp-relay maxhops 5
Related
Commands
service dhcp-relay
Parameter Description
<1-255> The maximum hop count value.
To Next Page
Loading...
Need help?
General
