C613-50100-01 REV C Command Reference for x930 Series 1628
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP STARTUP-QUERY-COUNT
ip igmp startup-query-count
Overview Use this command to configure the IGMP startup query count for an interface. The
IGMP startup query count is the number of IGMP General Query messages sent by
a querier at startup. The default IGMP startup query count is 2.
Use the no variant of this command to return an interface’s configured IGMP
startup query count to the default.
Syntax
ip igmp startup-query-count <startup-query-count>
no ip igmp startup-query-count
Default The default IGMP startup query count is 2.
Mode Interface Configuration for a VLAN interface.
Example To set the IGMP startup query count to 4 on vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip igmp startup-query-count 4
Related
Commands
ip igmp last-member-query-count
ip igmp startup-query-interval
Parameter Description
<startup-query-count> Specify the IGMP startup query count, in the range
2-10.
To Next Page
Loading...
Need help?
General
